Back to article
3329
Poor sound quality from product
If you experience distortion, crackling, static, noise or unexpected poor sound quality from your product:
Be sure the system is set up properly and all connections are secure.
A connection may have come loose or may be connected incorrectly. For more info, see Setting up your product.
Determine if the problem is specifically related to bass performance.
If there is too little bass, see Too little bass or too much treble from product.
If there is too much bass, see Too much bass or too little treble from product.
If there is too much bass, see Too much bass or too little treble from product.
Turn up the volume of the connected device.
Set the device volume to 90–100% to send a strong signal to your product. Then, use your product to adjust the volume level.
Check the bass and treble controls for your product.
Be sure the bass and treble adjustments are not set too high or too low for your preferences. For more info, see Adjusting the tone controls on your product.
Check if a different system EQ setting sounds better.
Press the SYSTEM EQbutton to scroll through the EQ options and determine if the setting is the issue. For more into, see Adjusting the tone controls on your product.
Reset your product.
Much like rebooting a smartphone, your product might need to be reset on occasion to correct minor issues. For more info, see Resetting your product.
Check the EQ settings on your Bluetooth® device.
The EQ settings of your Bluetooth device can affect sound. On the device, try setting the EQ to "off" or "flat" and disabling any other sound playback adjustments (i.e. loudness, compression, reverb, etc.). These settings are commonly found in the device's audio settings or in the settings of the app being used to play audio.
Plug in a different audio source.
Connected a different audio source to determine if the issue is related to the source: If audio is being sent to your system from a a microphone, try a different microphone; if an instrument is connected, try a different instrument.
Try a different output on the mixer or audio source.
If the audio source has more than one output (i.e. a mixer with main and aux outputs), connect to another output with the same cables to determine if the output is the issue.
Replace the input cables.
Try different input cables using the same source and same channel. If this solves the problem, the original cables may be defective.
A slight popping sound may be heard when changing the EQ switch position.
it is normal to hear a slight popping noise from your system when you change the position of the EQ switch.
Check for sources of interference.
Electronics can pick up interference from other electronics connected to the same power circuit or connected within close proximity. Try disconnecting the power cord from any such nearby electronics (i.e. laptop/phone charger, TV, cable box, seasonal lights, microwave, etc.). If the issue is resolved, try connecting the device or your product to a different power circuit or farther away.
Try a different powered speaker or sound system.
If available, connect a to different powered speaker to determine if the issue is related to the audio source or connecting cables.
Your product may need service.
If the steps provided do not resolve your issue, your product may need service. Follow the link below for more information on how to service your product. Depending on your product and region, you will be provided a contact number or the ability to setup service online.
Click here to start service
Click here to start service
Was this article helpful?
Thank you for your feedback!